HEATSHIELD STARTER SHIELD 1/16″ (1.5MM) X 3 1/2″ (89MM) X 18″ (458MM)

There’s nothing worse than revving up the engine & having your starter fail due to excessive heat. Prevent starter heat lock & take off with confidence with our HP Starter Shield™ starter heat wrap. Available in single & double-insulated models, this starter motor heat shield is ideal for all automotive applications & can even extend the life of your starter motor and solenoid.

Depending on the amount of airspace between the starter & the heat source in your vehicle, we offer different models of automotive engine heat shields. For especially tight spaces, we recommend this starter heat wrap, which comes in a medium size fit for most automotive applications & has a heat resistance of up to 595 °C continuous and 1100 °C intermittent.

Easy Hook-and-Loop Installation:
To make installation as easy as possible, we offer the HP Starter Shield™ in two convenient sizes. This saves you from needing to trim the shield down to the size of your starter. To install, simply wrap the starter heat wrap around the starter motor and fasten securely with the built-in hook-and-loop system. The hook-and-loop seam should be faced away from the heat source to avoid damage to the fasteners.

Quality Heatshield Products:
When choosing a starter motor heat shield, there’s nothing like the quality of the HP Starter Shield™ from Heatshield Products. We stand by our temperature ratings & offer you genuine products that are #racetested.

Features:

– Prevents starter heat soak so you are not stranded

– Easy installation, starter removal is not necessary

 Starter Heat Shield Installation tips:

– Face hook & loop seam opposite of heat source

– 501000/501010 are conductive, be sure to insulate & wire, terminals, or circuits that may come in contact with the shield

– Starter removal is not needed in most cases

– If you don’t have a 2.6 MM air gap between heat source and starter use part no. 500025